- New
- Out-of-Stock
Vlcc Insta Glow Diamond Bleach 30g
VLCC Natural Sciences Insta Glow Diamond Bleach, 30g Sparkling Fairness


VLCC Insta Glow Diamond Bleach
With real Diamond Bhasma
Diamond Bhasma or ash obtained through heating and pulverizing diamonds with herbs is an excellent skin purifier and hydrator, while Aloe Vera, also known as the plant of immortality has anti-allergic, anti-inflammatory, hydrating, healing and rejuvenating properties. VLCC Diamond Bleach offers an instant glow and polish to the skin. It bleaches the facial hair to match the skin tone perfectly and purifies the skin from within to make it fairer, energized and youthful.
- Enriched With Diamond Bhasma & Aloe Vera
- Complete 3 Step Bleach
- Lesser Tingling & Irritation
- Instant Fairness
Expert Advice:
- Do not apply on inflamed, chapped, irritated skin.
- Never apply bleach near the eyes. If mixture does get into eyes, rinse off with water immediately.
- Never use bleach after a hot bath. Open pores increase sensitivity.
- Never use metal dishes or applicators with cream bleach.
- Never mix the bleach cream and activator until you are ready to start treatment. Do not save mixed bleach for re-use.
- Do not use soap for 5 hours after bleach.
- Avoid going out in sunlight immediately, for better result apply in the evening.
- Mild irritation is natural during bleaching.
Directions of Use:
1. Wash the area to be bleached with soap & cold water. Pat dry.
2. Apply entire quantity of Pre Bleach Cream & massage gently till it gets absorbed. It prepare skin for the bleach
3. Mix Bleach Cream with Activator powder as per ratio mention over the pack. Mix the two well till the powder gets completely dissolved into the cream.
4. Apply the mixture immediately on the area to be bleached using the spatula. Make sure that the hair strands are completely covered. Avoid application on eyebrows and around the eyes.
5. Allow application to remain for the suggested time given under 'Recommended Time'. If hair is not lightened as much as desired, re-apply the mixture and leave on for 5 more minutes.
6. Wash off with cold water. Pat dry.
7. Apply a thin layer of the Post Bleach Pack, leave on for about 5 minutes then massage gently to facilitate complete absorption.
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent